Web Mountain Technologies RUC-01 Instrukcja Użytkownika Pobierz pdf (Strona 8)

And, we could do the same thing we did above with the RP command, use a UPB command or Zwave

command to trigger sending the ESI RQ command.

You might be asking how you could determine the addresses of the motor controllers on your ESI

network. There’s an easy way to do this if you have less than 12 or 13 motor controllers on your ESI

network. The RQ protocol specifies a global command - !000v?; - that tells all devices on the ESI

network to report their address and Version number. So, merely setup a trigger with this command,

RUN it, and then go look at the Receive webpage of the RUC. This page shows the last 15 commands

received by the RUC on both serial ports – COM1 & COM2. You’ll see a screen like this:

To interpret this, the RQ Bridge responded with !BR1vB10. The next four lines are the RQ motor

controllers (RQ60 units). You can see the addresses of the four motor controllers are T96, P9P, QFT, and

WBT. They are all Version # D15.

The following are some useful RQ commands that show you some examples of what you can do with the

RQ system and the RUC.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Brak uwag

Web Mountain Technologies RUC-01 Instrukcja Użytkownika Strona 8